If you need to power lights in a loco or rolling stock that has been gutted of the original electronics, this little board may help you. It provides three 5V voltage regulators powered from track voltage; 5V out in forward direction, 5V out in reverse, and 5V out in both directions. Each output is rated for 1 amp. Use with 5V lamps or LEDs with appropriate dropping resistors. 1.7" X 1.4" X 0.3" Wires connect to solder through holes on PCB. |
0 Comments
This is our new 3D printed case for the RailBoss 4 TX (transmitter). The primary goal of this project was to reduce the cost by eliminating the high priced 3rd party case. The 3D TX has the same radio with a range of 800 ft. line of site, but uses 2 AAA batteries instead of the harder to find AAAA batteries used in our standard TX. While not a contoured as our standard TX, it still feels comfortable in the hand and can be tethered around the neck. Left: Standard TX Right: 3D TX
Got a gadget you'd like to power from the track? This voltage regulator will power any device 3-35VDC, either aboard the train or trackside. More info here ...
If you are having problems keeping your MyLocoSound battery charged because you always run your loco at slow speeds, the Battery Booster will fix it. Instead of charging starting at 11V on the track, it will now start at 5V.
![]() Back 'n Forth Track Throttle operates with a built-in throttle. An automated point to point trolley or train adds action to any layout Requires diode isolated end stops and a separate power supply. ![]() It just keeps getting better ! New Enclosure
Back 'n Forth Trolley operation More Info ... Use the APTC to Automate a train display and/or just use it on your track powered layout as a manual speed control with automated station stops. This versatile 10 amp controller will control trains any way you want to.
|
Categories
All
|